New installs cover homes without central air, additions, converted garages and new builds. The company sizes the system, picks the equipment location and connects the ducts, drain and power. That process works for any Rhome property. Call the number on this page to be connected with a local AC company in Rhome.

Is this an install or a swap?
If an existing central system is being taken out and replaced, that is replacement work. An installation means designing and adding cooling where none exists, or adding a second zone for an addition. The planning is broader because the house has to be assessed from scratch. Knowing which one you need keeps the conversation with the company focused.
What the company will look at in Rhome
- Home size, ceiling height and number of floors
- Insulation in the attic and walls
- Window area and which way they face
- Duct leakage and the number of occupants
The smaller the margin for error, the more a careful calculation helps, particularly in houses with large windows or vaulted rooms.
Acreage homes often include detached garages, barns converted to living space and long electrical runs. Describe all of it when you call so the company can plan correctly.
Drain, pan and float switch
The indoor unit needs a condensate drain that slopes properly and ends somewhere safe. When the air handler sits in the attic, a secondary pan and float switch are worth including so a clogged line does not stain the ceiling below. These are small parts of the budget compared with the damage a water leak can cause in a finished ceiling or wall.
Choosing the indoor location
The air handler and coil can go in an attic, a closet or a garage. Attic units save floor space but sit in extreme heat and are harder to service. Closets are easier to reach but use living space. The best choice depends on the house. Ask the company which fits your house.
What a finished install should include
You should see a system that starts, cools every room reasonably, drains properly and is explained to you. Ask for model information, the thermostat instructions and any manufacturer paperwork. A short walk-through at the end catches small problems early. Keep the paperwork in a safe place for future service and resale, and note the model information for the outdoor unit.
Local details for Rhome
Before you approve the work, check the company's ACR contractor license with TDLR; the state agency also takes complaints about AC contractors.
Federal rules require EPA 608 certification for technicians who service equipment containing refrigerant, which covers most AC repairs beyond filters and breakers.
Replacement and new installation work can require a permit, and Rhome Permitting Department is where that's handled for Rhome addresses.
Rhome is in Oncor's delivery area: Oncor maintains the lines and restores outages (888-313-4747), while you buy power from the retail electric provider you chose.
Companies that take calls here usually also work in Fort Worth, Saginaw and Northlake.
AC Installation questions in Rhome
Will my electrical panel support a new AC?
Should the attic or a closet hold the air handler?
What is the difference between an install and a replacement?
How can I check a company before it works on my house?
More AC and heating services in Rhome
AC Installation nearby
Helpful guides
Sources
Last updated: