If the furnace has sat idle since last winter, the first cold night often exposes a dirty sensor, a weak ignitor or a clogged filter. Those are routine repairs. Call the number on this page to be connected with a local heating company in Kennedale.

Before you call, check these
- Set the thermostat to heat and raise it a few degrees.
- Replace thermostat batteries if it has them.
- Check the furnace switch and the breaker.
- Look at the filter; a clogged one can shut the furnace down.
- Note any blinking light or sounds so you can describe them.
Ignitor trouble
Most modern gas furnaces light with a hot surface ignitor, a fragile element that glows to light the gas. It cracks with age and heat cycles. When it weakens, the furnace clicks, the ignitor may glow dimly or not at all, and the burners never light. Replacing it is one of the more routine furnace repairs.
Who handles what in Kennedale
Before you approve the work, check the company's ACR contractor license with TDLR; the state agency also takes complaints about AC contractors.
Smell gas near the furnace? Get everyone out, call 911 and then Atmos Energy (866-322-8667) once you're outside. Don't flip switches on the way.
For Kennedale addresses, Kennedale's Building Inspections Division handles mechanical permits; a system change-out is permitted work, and the contractor normally pulls the permit.
Kennedale is in Oncor's delivery area: Oncor maintains the lines and restores outages (888-313-4747), while you buy power from the retail electric provider you chose.
Nearby, the same kind of help is available in Fort Worth, Everman and Forest Hill.
What affects furnace repair cost
The price depends on which part failed, how hard it is to reach and how old the furnace is. A sensor cleaning is a short job; a gas valve or control board costs more. Attic and tight-closet access add labor. Ask for the diagnosis and the repair price in writing before you approve the work.
What happens when the technician arrives
The technician asks about symptoms, then watches the furnace run through its start-up sequence: inducer, ignitor, gas valve, flame and blower. Along the way they check the filter, vents and safety switches. You should get a clear finding, a price and a choice before any parts are replaced.
Why CO alarms matter at the first cold snap
Homes are closed up, furnaces run for hours and vent problems show up when the first cold night arrives. Check that CO alarms work and have fresh batteries before the cold hits. If one sounds, treat it as real, leave, and call 911; do not wait to see if it stops.
Furnace Repair questions in Kennedale
Why does my furnace click but not light?
Is a yellow flame in my furnace dangerous?
What should I do if I smell gas near the furnace?
Will a furnace repair fix my high heating bills?
More AC and heating services in Kennedale
Furnace Repair nearby
Sources
Last updated: