A furnace that runs but will not heat is most often held up by a worn ignitor, a dirty flame sensor or a safety switch that keeps tripping. A technician can test each part in a single visit. Call the number on this page to be connected with a local heating company in Arlington.

Signs your furnace needs repair
The common signs are no heat at all, warm air that turns cool partway through a cycle, a furnace that starts and stops every few minutes, and clicking with no flame. Weak airflow and a pilot or burner that never catches also count. If the thermostat is set to heat and the house still drops, it is time to call.
Control board and blower issues
The control board runs the ignition sequence and reads each switch. When it fails, or when a blower motor or capacitor weakens, the furnace can stall in odd ways: no response, repeated restarts or a blower that will not stop. Those faults take a meter and a methodical test to sort out.
Why quotes differ between companies
Two independent companies can quote the same furnace differently because they price labor, diagnosis time and parts differently. Some charge a service fee that is applied to the repair if you go ahead. Ask how the diagnosis fee works, and compare quotes for the same described repair.
Local details for Arlington
Texas requires anyone contracting for air conditioning and refrigeration work to hold an ACR contractor license from the Texas Department of Licensing and Regulation (TDLR). Ask for the license number and check it on TDLR's license search.
Gas furnaces here are served by Atmos Energy. If you smell gas, leave the house, call 911, then call Atmos Energy at 866-322-8667 from outside.
Arlington's Planning & Development Services requires a mechanical permit for replacing or changing out heating and cooling equipment, so ask whether the contractor will pull it.
Arlington is in Oncor's delivery area: Oncor maintains the lines and restores outages (888-313-4747), while you buy power from the retail electric provider you chose.
Companies that take calls here usually also work in Fort Worth, Kennedale and Forest Hill.
What the company should explain
Before the visit ends, ask what was found, what was replaced and what to monitor. Good follow-up advice is short: stay on top of filters, leave the vents open, and phone again if the same fault returns. Hold on to the invoice in case a part is covered.
Keep it safe between visits
Change filters on schedule, keep the area around the furnace clear of boxes and chemicals and never block the combustion air or flue. Do not remove panels or bypass a safety switch to get heat. A tripped switch means something is wrong, and bypassing it is how small faults become hazards.
Around Arlington
Calls come in from across Arlington, including around Downtown Arlington, East Arlington, Entertainment District.
About 38% of Arlington's housing units were built before 1980 and roughly 21% were built in the 1970s alone, so a large share of homes are 40 or more years old.
Furnace Repair questions in Arlington
My carbon monoxide alarm went off. What do I do?
What should I do if I smell gas near the furnace?
Should I repair or replace an old furnace?
What happens if I call this number?
More AC and heating services in Arlington
Furnace Repair nearby
Sources
Last updated: