A furnace that runs but will not heat is most often held up by a worn ignitor, a dirty flame sensor or a safety switch that keeps tripping. A technician can test each part in a single visit. Call the number on this page to be connected with a local heating company in Watauga.

Sounds that point to trouble
Repeated clicking suggests an ignition problem. A loud bang when the burners start, a rattle from the blower or a squeal that rises and falls each deserve attention. A furnace that is simply quiet and cold, with the house dropping, may have tripped a safety. Describe the sound when you call; it helps the technician bring the right parts.
Airflow problems that mimic part failures
A dirty filter, closed or blocked registers and crushed ductwork choke airflow, and a choked furnace overheats and cycles on the limit switch. The furnace itself may be fine. A good technician checks airflow along with the parts, which is why a filter change is worth doing before the first call.
Who handles what in Watauga
Before you approve the work, check the company's ACR contractor license with TDLR; the state agency also takes complaints about AC contractors.
Gas furnaces here are served by Atmos Energy. If you smell gas, leave the house, call 911, then call Atmos Energy at 866-322-8667 from outside.
Replacement and new installation work can require a permit, and Watauga's Development Services office is where that's handled for Watauga addresses.
Power outages here go to Oncor at 888-313-4747, not to your retail electric provider. If the AC and the lights are both out, check that first.
Nearby, the same kind of help is available in Fort Worth, North Richland Hills and Haltom City.
Why quotes differ between companies
Two independent companies can quote the same furnace differently because they price labor, diagnosis time and parts differently. Some charge a service fee that is applied to the repair if you go ahead. Ask how the diagnosis fee works, and compare quotes for the same described repair.
If the news is a replacement
Sometimes the finding is a cracked heat exchanger or a board and valve failing together on an old furnace. You are free to get a second opinion before agreeing. This referral line can connect you with another independent company to compare findings and options without any pressure.
Carbon monoxide basics
Carbon monoxide is odorless, and a failing furnace can be one source. The Consumer Product Safety Commission advises CO alarms on each level of the home and near sleeping areas, tested regularly. If an alarm sounds, get everyone outside and call 911 before doing anything else.
Furnace Repair questions in Watauga
What does a flame sensor do?
Why does my furnace keep shutting off after a few minutes?
Is a yellow flame in my furnace dangerous?
My carbon monoxide alarm went off. What do I do?
More AC and heating services in Watauga
Furnace Repair nearby
Sources
Last updated: