Short cycling, no heat and cold air from the vents each trace back to a small set of furnace parts: the ignitor, flame sensor, pressure switch, limit switch and the airflow around them. Call the number on this page to be connected with a local heating company in Weatherford.

Is it the thermostat or the furnace?
Start with the simple parts. Confirm the thermostat is on heat, the setpoint is above the room temperature and the batteries are fresh. Make sure the furnace switch is on and the breaker has not tripped. If everything checks out and nothing happens, the problem is inside the furnace, and that is a job for a technician.
Why safety switches trip
- Pressure switch: confirms the draft inducer is moving air before gas flows
- Limit switch: shuts the furnace down if the heat exchanger gets too hot
A switch that trips is doing its job, so the technician looks for the cause, such as a clogged filter, blocked vent or weak inducer motor.
Houses in Weatherford are fairly new, built around 1999 on average, so ask whether the furnace is still under a parts warranty before paying for a repair.
Questions that keep the bill clear
- What exactly failed, and can you show me?
- Is the diagnosis fee applied to the repair?
- Is the part new, and does it carry a manufacturer warranty?
- Are there other worn parts likely to fail soon?
What to tell the dispatcher
Mention whether the furnace clicks, lights then quits or does nothing, and whether any light is blinking on the control board. Say whether it is in an attic, a closet or the garage. Those few details help the company send someone with the right parts and plan for access.
Warning signs to take seriously
- Soot or scorch marks near the furnace
- Water pooling around the base
- A burning smell that lingers after the first startup
- Headaches or nausea when the heat runs
- Flames that roll out of the cabinet
Shut the furnace off and get help.
Local details for Weatherford
Before you approve the work, check the company's ACR contractor license with TDLR; the state agency also takes complaints about AC contractors.
Texas Gas Service is the gas utility for Weatherford; its leak line is 800-959-5325. Leave first, then call 911 and the utility from outside.
If the job is a full replacement, expect a mechanical permit through Weatherford's Building Division. Ask who pulls it and when the inspection happens.
If the AC and the rest of the house lose power together, call your electric utility's outage line before calling for repairs.
Companies that take calls here usually also work in Fort Worth, Willow Park and Hudson Oaks.
More about Weatherford
The median house or condo in Weatherford was built in 1999, so many homes have newer-generation systems; the city lists HVAC work among permit-required work.
Furnace Repair questions in Weatherford
Is a yellow flame in my furnace dangerous?
My carbon monoxide alarm went off. What do I do?
Can I fix my furnace myself?
How often should a furnace be serviced?
More AC and heating services in Weatherford
Furnace Repair nearby
Sources
Last updated: