A furnace that runs but will not heat is most often held up by a worn ignitor, a dirty flame sensor or a safety switch that keeps tripping. A technician can test each part in a single visit. Call the number on this page to be connected with a local heating company in Flower Mound.

Sounds that point to trouble
Repeated clicking suggests an ignition problem. A loud bang when the burners start, a rattle from the blower or a squeal that rises and falls each deserve attention. A furnace that is simply quiet and cold, with the house dropping, may have tripped a safety. Describe the sound when you call; it helps the technician bring the right parts.
Flame sensor buildup
A thin metal rod sits in the burner flame and confirms to the board that the fire is real. Over a season it picks up a film that blocks that signal. The burners then light for a few seconds and shut down. Cleaning or replacing the sensor usually gets the furnace running again.
With homes here built around 1997, many furnaces are young enough that a single failed part is the likely story, and repair is usually reasonable.
When a repair stops making sense
If the furnace is near the end of its life and the failed part is expensive, spending on the repair can be a poor trade. The tech's answer to a simple question helps: if this part is fixed, what is likely to go next? Treat that as input, not pressure, and take your time deciding.
What happens when the technician arrives
The technician asks about symptoms, then watches the furnace run through its start-up sequence: inducer, ignitor, gas valve, flame and blower. Along the way they check the filter, vents and safety switches. You should get a clear finding, a price and a choice before any parts are replaced.
Local details for Flower Mound
The Texas Department of Licensing and Regulation issues ACR contractor licenses. A quick license lookup on TDLR's site is worth doing before you sign a proposal.
Gas furnaces here are served by Atmos Energy. If you smell gas, leave the house, call 911, then call Atmos Energy at 866-322-8667 from outside.
Flower Mound Building Inspections requires a mechanical permit for replacing or changing out heating and cooling equipment, so ask whether the contractor will pull it.
Flower Mound is in Oncor's delivery area: Oncor maintains the lines and restores outages (888-313-4747), while you buy power from the retail electric provider you chose.
Calls from Flower Mound are often matched with companies that also cover Fort Worth, Southlake and Grapevine.
If you smell gas
Leave the house right away. Do not flip switches, use a phone inside or try to find the source. Once you are outside, call 911 and your gas utility. Wait for the all-clear before going back in. A gas smell is never a wait-and-see problem, and it comes before any furnace repair.
Flower Mound at a glance
Calls come in from across Flower Mound, including around FM 2499 (Long Prairie Road), FM 1171, Lakeside Parkway.
Median year built for houses and condos is 1997, so much of the housing stock is a few decades old and past typical first AC system replacement age.
Furnace Repair questions in Flower Mound
Why does my furnace click but not light?
Why does my furnace keep shutting off after a few minutes?
How often should a furnace be serviced?
Why does my furnace smell when I first turn it on?
More AC and heating services in Flower Mound
Furnace Repair nearby
Sources
Last updated: