When one room stays hot and the rest of the house is fine, the cause is often a duct, not the air conditioner. A disconnected, kinked or leaking run can starve a room of air. Call the number on this page to be connected with a local AC company in Cleburne.

How to tell it is the ducts, not the AC
If the system blows cold at the air handler but a back bedroom stays warm, the equipment may be fine. Compare vents room to room. One weak vent points to its own run. Several weak vents at the far end of the house suggest a leak or restriction upstream.
Disconnected joints and loose collars
Where a duct meets the plenum, a boot or a register, it is held with a strap and sealant. Vibration, heat and old tape can let it slip. A fully disconnected run dumps all its air into the attic, which is one of the more common causes of a room that never cools.
Other things that add to the bill
Removing old insulation, working around wiring, patching a ceiling after a repair, or opening a wall to reach a run can all add cost. So can adding returns or supply runs to fix airflow. Ask what is included and what would be extra before work begins.
Timing the work
Attic work is hardest in the afternoon heat, so crews often prefer morning visits for the summer months, and scheduling depends on the company. Smaller repairs may be done in one visit. A full replacement is a bigger project that is planned in advance.
Local details for Cleburne
Before you approve the work, check the company's ACR contractor license with TDLR; the state agency also takes complaints about AC contractors.
Refrigerant handling falls under EPA Section 608: the technician who connects gauges or recovers refrigerant needs that certification.
Cleburne's Building Inspections Division requires a mechanical permit for replacing or changing out heating and cooling equipment, so ask whether the contractor will pull it.
Cleburne is in Oncor's delivery area: Oncor maintains the lines and restores outages (888-313-4747), while you buy power from the retail electric provider you chose.
Companies that take calls here usually also work in Fort Worth, Keene and Joshua.
When to replace instead of repair
Replace when the flex is brittle or collapsing across the attic, when many runs are crushed, when rodents have damaged much of it, or when the layout is simply wrong. Patching a worn system tends to chase one leak after another.
Ductwork Repair & Replacement questions in Cleburne
Do I need a permit to replace ductwork?
What does it mean if a duct is sweating?
Is ductwork repair different from duct cleaning?
How do I check a contractor's license?
More AC and heating services in Cleburne
Ductwork Repair & Replacement nearby
Helpful guides
Sources
Last updated: