If the furnace has sat idle since last winter, the first cold night often exposes a dirty sensor, a weak ignitor or a clogged filter. Those are routine repairs. Call the number on this page to be connected with a local heating company in Alvarado.

Before you call, check these
- Set the thermostat to heat and raise it a few degrees.
- Replace thermostat batteries if it has them.
- Check the furnace switch and the breaker.
- Look at the filter; a clogged one can shut the furnace down.
- Note any blinking light or sounds so you can describe them.
Flame sensor buildup
A thin metal rod sits in the burner flame and confirms to the board that the fire is real. Over a season it picks up a film that blocks that signal. The burners then light for a few seconds and shut down. Cleaning or replacing the sensor usually gets the furnace running again.
On larger lots around Alvarado, long driveways and homes far from a supply house can stretch parts delivery, so describing the symptoms well helps the company arrive prepared.
Timing and price in Alvarado
Repair calls spike on the first cold nights, when companies are busy and parts run short. A planned fall tune-up costs less than a no-heat call in January, and it gives the technician time to spot parts that are wearing. Prices vary by company, so ask before you agree.
Who handles what in Alvarado
The Texas Department of Licensing and Regulation issues ACR contractor licenses. A quick license lookup on TDLR's site is worth doing before you sign a proposal.
Gas furnaces here are served by Atmos Energy. If you smell gas, leave the house, call 911, then call Atmos Energy at 866-322-8667 from outside.
Replacement and new installation work can require a permit, and Alvarado's Community Development Building Safety Division is where that's handled for Alvarado addresses.
Alvarado is in Oncor's delivery area: Oncor maintains the lines and restores outages (888-313-4747), while you buy power from the retail electric provider you chose.
Companies that take calls here usually also work in Fort Worth, Venus and Keene.
A good diagnosis sounds like this
You should hear which component failed and why, not just that the furnace needs work. A technician should also tell you whether the cause was a wear item or something upstream, like restricted airflow, that will cause the same fault again. Ask questions; a clear answer is a good sign.
Keep it safe between visits
Change filters on schedule, keep the area around the furnace clear of boxes and chemicals and never block the combustion air or flue. Do not remove panels or bypass a safety switch to get heat. A tripped switch means something is wrong, and bypassing it is how small faults become hazards.
Furnace Repair questions in Alvarado
What does a flame sensor do?
My carbon monoxide alarm went off. What do I do?
What happens if I call this number?
Why does my furnace run all the time?
More AC and heating services in Alvarado
Furnace Repair nearby
Sources
Last updated: